INTRODUCTION:

With this board you can develop and prototype with any of Microchip's 28 pin PIC microcontrollers. The RS232 driver on board allows easy connection with PC or other embedded hardware. The board have User button and status LED. The bridge rectifire allow this board to be powered with both AC and DC power supply adapters. PIC-P28 supports both 3V low power and normal 5V operation.

FEATURES:

• ICSP/ICD connector for programming with PIC-MCP-USB, PIC-MCP or PIC-PG1, PIC-PG2, PIC-PG3, PIC-PG4 programmers or debugging with PIC-ICD2, PIC-ICD2-POCKET, PIC-ICD2-TINY(* for the PICs with ICD support), PIC16F87x processors are supported by the low cost PIC-ICD1.
• RS232 Tx, Rx interface with MAX232 IC on socket
• DIL28 microcontroller socket
• Quartz crystall 20Mhz
• LED to RA0 through jumper
• user Button on RA5 port
• Reset button
• Power plug-in jack
• selectable +3.3V / +5V power supply voltage regulator
• Extension slot on every uC pin
• Gird 100 mils
• GND bus
• Vcc bus
• Four mounting holes 3,3 mm (0,13")
• FR-4, 1.5 mm (0,062"), green soldermask, white silkscreen component print
• Dimensions 100x80 mm (3,9x3,15")

DOCUMENTS:

• PIC-P28.pdf - Users manual

HARDWARE:

• PIC-P28 schematic
• PIC ICSP connector

• Blink LED for PIC16F876 demo code (C source and HEX)
• Button read for PIC16F876 demo code (C source and HEX)
• RS232 read/write for PIC16F876 demo code (C source and HEX)

ORDERING CODES:
		PIC-P28-20MHz completely assembled and tested with 20MHz oscillator	
		PIC-P28/PCB ONLY